Installation manual fascia boards

Important:

Store panels flat, dry and covered (not in direct sunlight).
Always check the materials for any defects before processing them.
10 mm dilatation joints (expansion gap) between the top sides of the panels and all auxiliary profiles.
Heated air behind the panels must be able to dissipate above and below through sufficient ventilation.

Processing:

The fascia board can be processed using regular woodworking tools. Use a standard fine-toothed circular saw or hand saw. It is also possible to mitre and install the parts (6b).

Installation:

The fascia board must be fastened to a framework or roof trusses, at a maximum centre-to-centre distance of 40 cm with (coloured) screws or nails. When installing, allow for sufficient ventilation by using ventilation slots or grilles.

The top layer must be covered with the cover strip that is glued over the seam. If a gutter is to be installed on the fascia board, care must be taken that the gutter is always fastened to the wood backing.